Rivera Primo Brute III Extreme 2007 Touring Enclosed Belt Drive - Manual (Page 3)

Friction plate 2nd, then alternate steel,
friction, steel, friction. The clutch
plates should be installed in the same
order as delivered. The clutch pack
height is pre-set prior to shipment, &
should not be altered without consult-
ing a Primo technician.
Friction Plate plate second...
Install the pressure plate (Figure
11). When installing the shouldered
nuts make sure that the mating
threaded bolt has anti seize on it
(Figure 11A).
Install the pressure plate
Install the diaphragm spring, spring retainer (beveled side inward against the
spring) and shoulder bolts as shown. Tighten the 4 shoulder nuts equally
until they bottom. Spring adjustment (and clutch pack height) is established
prior to shipping but should be checked prior to finishing install.
Install the pressure plate assembly & adjust the clutch.
12
Belt should have 1/4”- 3/4” of up & down play when the drive train is cold. Re-install the outer primary
cover and double check belt clearance. Install a louvered or vented derby cover (belt drive must have air
flow) and don’t reinstall the primary drain plug, then you’re ready to ride. Check belt tension after the
drive train reaches normal operating temperature (15-20 minutes of riding at 55 MPH in ambient air tem-
perature of 68 degrees). The belt should feel snug but not excessively tight!
ATTENTION!
Turn out the cable adjustment until the clutch lever rests against
the grip. Start the center adjusting screw in the threaded hole
on the pressure plate & then turn the center screw in until the
clutch lever just starts to move away from the grip, then turn the
center screw out ¼ of a turn and lock the center adjusting screw
jam nut firmly against the pressure plate. Now adjust a black
clutch cable so you have approx. 1/8" free play from the clutch
cable ferrule to the clutch lever perch and on a braided clutch
cable you will have almost no free play.
After installing the .120” steel drive
plate, Install the rest of the clutch
pack per steps 10 and 11.
9A
CLUTCH HUB INFORMATION
Install the .120” thick steel plate at the
rear of the clutch pack as shown. The
clutch pack can then be installed.
.120” thick Steel Plate plate first.
10
ADJUST THE CLUTCH
THIS WAY!!!
11
11A
9
Page 3