Rivera Primo Brute Force - Manual (Page 6)

STEP 14 :
Install the “INNER” OUTBOARD BEARING SUPPORT PLATE
with the "bearing support shaft" into the front pulley and
install the bottom-front bearing STAND-OFF (part # 2160-0062,
4.032” long with 2 flats & four tapped holes) between the
motor plate and the front bearing support.
This STAND-OFF has threaded holes to secure the front
of the upper and lower carbon fiber belt guards.
Do not tighten this STAND-OFF at this time. It must be
rotated to align the holes when installing and securing the
upper and lower carbon fiber belt guards.
STEP 15 :
Install the “OUTER” OUTBOARD BEARING SUPPORT section onto the clutch basket assembly. Use the short stand-off
(.747”) at the top and the long STAND-OFF with one flat with two tapped bolt holes (secures the rear of the lower belt
guard) on the bottom to attach the outer bearing support to the rear motor plate section. Install the 5/16”-18 X 2” bolt thru
the .747” STAND-OFF (TOP REAR), and 5/16”-18 x 5 1/2” bolt through the bottom rear STAND-OFF (use blue thread
lock). Use the 5/16”-18 X 1 1/4” bolts to secure the front of the outer bearing support to the STAND-OFFS already installed
on the rear motor plate. Tighten all the bolts equally. TORQUE TO 29 FOOT POUNDS.
Secure the center of the outer OUTBOARD BEARING SUPPORT to the center STAND-OFFS with the two
5/16”-18 X 1 1/4” bolts provided & TORQUE TO 29 FOOT POUNDS.
ANTI-SEIZE MUST BE APPLIED TO THE THREADS
OF THE SPIN-ON BEARING SUPPORT-SHAFT
HUB-CAP.
STEP 16 :
Install the "Brute Force" NAME PLATE onto the bearing
support assembly using the 10-32 X 3/8” socket flat cap
bolt. Use one drop of blue threadlock & snug the bolt.
.747” STAND-OFF
4.733” STAND-OFF with one flat & two holes
APPLY ANTI-SEIZE TO THESE THREADS
6