Rivera Primo Grip Ace - Manual

12450 Whittier Blvd.~ Whittier, CA 90602 ~ 562-907-2600 ~ 562-907-2606 fax
[email protected] ~ www.riveraprimoinc.com
Grip Ace™ Wiring Instructions
1.
Red wire: Main power source of Grip Ace™ system. Must be connected to
a 12 volt lead with a max 15 amp fuses. This lead is hot only when the key or
power switch on motorcycle is turned on. The brake light power lead is the
optimal location for this connection. This is the lead that supplies power to
the brake light switches.
2.
Black wire: Must be grounded to frame, negative battery terminal or a
negative lead in the wire harness.
3. Yellow w ire: 65 watts max. Two ways to connect. The first is to connect to
the wire in motorcycles harness that sends power to the head light hi/lo beam
switch. Second and the preferable way would be to connect the
. Yellow
Grip Ace™ wire to the same source of power as Red wire of Grip Ace™. Then
use a standard 30 amp automotive relay. Connect the head light power source
that goes to Hi/Lo beam switch from motorcycle to terminal 30. Connect low
beam lead that goes to low beam head light to terminal 87a, connect high
beam lead that goes to the high beam head light to terminal 87, connect
negative ground to terminal 86 and connect the Violet wire from Grip Ace™ to
terminal 85. This relayed way is also for custom applications. You won't go
wrong!
4.
Violet wire: Connect directly to high beam lead going to high beam head
light that comes from Hi/Lo switch or connect to relay as described in yellow
wire explanation.
5.
Blue wire: Connect directly to low beam lead going to the low beam head
light that comes from the Hi/Lo beam switch or connect to relay as described
in yellow wire explanation. Note: If low beam is hard wired directly to fuse in
fuse box, then the Blue Grip Ace™ lead is not needed in this application.
6. White wire: Connect to the wire going to the turn signal switch that comes
from turn signal flasher relay or turn signal power source for Harley®
motorcycles. Use of load pack for L.E.D turn signals may not be needed. On
customs connect to
12450 Whittier Blvd.
Whittier, CA 90602
www.riveraprimoinc.com 562-907-2600
562-907-2606 fax
[email protected]