American Audio DCD-PRO1000 - Manual (Page 13)

DIGIT AL
OUT
CONNECT T O
REMO TE CONTROL
2
CONNECT T O
REMO TE CONTROL
1
A UDIO OUT A UDIO OUT
DIGIT AL
OUT
Figure 4
GENERAL FUNCTIONS AND CONTROLS (Cont.)
© American Audio ® - www.americanaudio.us - DCD-PRO1000™ Instruction Manual Page 13
B. TRANSPORT UNIT (FIGURE 4)
39. DRIVE 2 TRANSPORT TRAY - This tray is
used to load and unload a compact disc in to the
drive 2 mechanism. The tray is opened and closed
by pressing the DRIVE 2 OPEN/CLOSE BUTTON
(40). Never attempt to force the transport tray to
open or close when the power is turned off.
40. DRIVE 2 OPEN/CLOSE (Transport Tray
Open/Close) - This button is used to open and
close the drive 2 transport tray. NOTE: When a
disc is already loaded in the transport tray, the
tray will not open unless the unit is in pause or
cue mode.
41. POWER SWITCH - This switch is used to
control the unit's main power. A blue L.E.D.
directly above the power switch will glow to indi-
cate main power is active.
42. DRIVE 1 OPEN/CLOSE (Transport Tray Open/Close) - This button is used to open and
close the drive 1 transport tray. NOTE: When a
disc is already loaded in the transport tray, the
tray will not open unless the unit is in pause or
cue mode.
43. DRIVE 1 TRANSPORT TRAY - This tray is
used to load and unload a compact disc in to
the drive 1 mechanism. The tray is opened and
closed by pressing the DRIVE 1 OPEN/CLOSE
BUTTON (42). Never attempt to force the to
transport tray open or close when the power is
turned off.
44. DRIVE 1 AUDIO OUT R & L - These jacks
send a left and right analog mono output signal.
Use these jacks to send standard audio to a mixer
or receiver. The red colored jack represents the
right channel output and white jack represents
39
44
43 42 41 40
51 50 49 48 47 46 45