General power tool safety warnings, Description of symbols, Specification – Silverline Video Inspection Camera User Manual

Page 7

Advertising
background image

6

GB

Carefully read and understand this manual and any label

attached to the tool before use. Keep these instructions with the

product for future reference. Ensure all persons who use this

product are fully acquainted with this manual.

Even when used as prescribed it is not possible to eliminate all

residual risk factors. Use with caution. If you are at all unsure

of the correct and safe manner in which to use this tool, do not

attempt to use it.

General Power Tool Safety

Warnings

WARNING Read all safety warnings and all instructions.

Failure to follow the warnings and instructions may result in

electric shock, fire and/or serious injury.

Save all warnings and instructions for future reference.

The term "power tool" in the warnings refers to your mains-

operated (corded) power tool or battery-operated (cordless)

power tool.

Work Area Safety

a)

Keep work area clean and well lit. Cluttered or dark areas

invite accidents

b)

Do not operate power tools in explosive atmospheres,

such as in the presence of flammable liquids, gases or

dust. Power tools create sparks which may ignite the dust

or fumes

c)

Keep children and bystanders away while operating a

power tool. Distractions can cause you to lose control

Electrical Safety

a)

Power tool plugs must match the outlet. Never modify

the plug in any way. Do not use any adapter plugs with

earthed (grounded) power tools. Unmodified plugs and

matching outlets will reduce risk of electric shock

b)

Avoid body contact with earthed or grounded surfaces,

such as pipes, radiators, ranges and refrigerators. There

is an increased risk of electric shock if your body is earthed

or grounded

c)

Do not expose power tools to rain or wet conditions.

Water entering a power tool will increase the risk of electric

shock

d)

Do not abuse the cord. Never use the cord for carrying,

pulling or unplugging the power tool. Keep cord away

from heat, oil, sharp edges or moving parts. Damaged or

entangled cords increase the risk of electric shock

e)

When operating a power tool outdoors, use an extension

cord suitable for outdoor use. Use of a cord suitable for

outdoor use reduces the risk of electric shock

f)

If operating a power tool in a damp location is

unavoidable, use a residual current device (RCD)

protected supply. Use of an RCD reduces the risk of electric

shock

NOTE: The term “residual current device (RCD)” may be

replaced by the term “ground fault circuit interrupter (GFCI)”

or “earth leakage circuit breaker (ELCB)”.

Personal Safety

a)

Stay alert, watch what you are doing and use common

sense when operating a power tool. Do not use a power

tool while you are tired or under the influence of drugs,

alcohol or medication. A moment of inattention while

operating power tools may result in serious personal injury

Description of Symbols

The rating plate on your tool may show symbols. These represent

important information about the product or instructions on its use

Wear hearing protection

Wear eye protection

Wear breathing protection

Wear head protection

Wear hand protection

Read instruction manual

Conforms to relevant legislation and safety standards

Environmental Protection

Waste electrical products should not be disposed of

with household waste. Please recycle where facilities

exist. Check with your local authority or retailer for

recycling advice

Specification


Imaging sensor:................... CMOS
Total pixels: ........................ 640 x 480 (PAL) /

........................................... 640 x 480 (NTSC)

Horizontal viewing angle: .... 36°
Minimum illumination: ......... 0 Lux
Power: ................................ 4 x AA batteries
Waterproof capacity: .......... IP67 (lens/tube only)
LCD screen type: ....................2.7° TFT – LCD
Cable diameter: ................... 9mm
Cable length: ....................... 1m
LCD effective pixels: ............ 960 x 240
Video system: ...................... PAL / NTSC
Capacity of micro SD card: . Supports up to 32G
Picture type: ........................ JPEG
Video type: .......................... .AVI
Picture/video pixels: ............ 640 x 480
Video size: .......................... 27Megabyte per min
Frame rate:.......................... 5-30 frames per second,

........................................... adjustable.

Data transmission: .............. USB 2.0
Dimensions: ....................... 263 (W) x 86 (D) x 49 (H) mm

...................................................(excl. flexible tube)

Weight: ................................ 420g (approx.)
Operating temperature: ...... 10 - 50°C / 14° - 122° F
Operating humidity: ............. 15 - 85%RH

As part of our ongoing product development, specifications of

Silverline products may alter without notice.

913738_Z1MANPRO1.indd 6

27/07/2012 12:22

Advertising