SawStop Over-Arm Dust - Manual

Over-Arm Dust Collection
Installation Guide
For SawStop Contractor saws
with a Standard Fence Assembly
BEGIN HERE
3 mm hex key
4 mm hex key
Tools:
For all SawStop cabinet saws
and for Contractor saws with
T-Glide Fence Systems
2”
1.
Slide clamps D onto tube C.
22”
C D D
(For a Contractor saw with a
Standard Fence Assembly.)
Continue on the back side
Install brackets A by replacing the bolts on
the rear rail of the contractor saw with bolts
B in the locations shown above. Reinstall
the lock washer and nut on the end of each
bolt. Continue with steps 1-6 below.
Tools:
Two 13 mm wrenches
L-brackets
bolts
A
B
C D
(For all saws except Contractor saws
with Standard Fence Assemblies.)
A
B
lower dust tube
upper dust tube
splitter
short hose
long hose
clamps with
screws
C
D
E
F
G
H
D
BEGIN HERE
2”
SawStop
rear rail