Muxlab Rackmount Balun Chassis 16 User Manual
Page 2
Advertising
© MuxLab Inc. 2007
3.
Install each balun in its appropriate slot. In order to install each balun, push the balun
into the desired slot from the rear of the Balun Chassis. The slots are numbered “1”
to “16”. Each balun snaps into place and is retained by a spring-steel retaining clip.
4.
The baluns may be installed either front or rear facing. In order to remove each
balun, lift the spring retaining clip at the rear of the chassis and pull out the balun in a
horizontal direction.
Balun
5.
The following diagram shows a typical application.
Advertising