Muxlab Rackmount Balun Chassis 6 - Manual

© MuxLab Inc. 2009
Specifications
Environment Custom audio-video systems in a structured cabling environment.
Application Head-end installations, audio-video rooms, telecom rooms.
Capacity Six (6) positions.
Compatible baluns MuxLab baluns measuring: 2.4” x 2.25” x 1” (6.1 x 5.7 x 2.5 cm).
Orientation Baluns may be installed front or rear facing.
Snap-in mechanism Baluns lock into position via spring latch mechanism.
Rack height 1U (1.75”).
Enclosure Black painted steel.
Mounting holes Four (4) rackmounting holes
Mounting hardware Four (4) rackmounting 10-32 screws and washers are included.
Slot Id Silkscreen on front and rear. Slots numbered “1” to “16”.
Dimensions 19” (W) x 1.75” (H) x 3.0” (D) (48 cm x 4.45 cm x 7.6 cm).
Weight 1.9 lbs (.86 kg).
Standards EIA/TIA.
Warranty Lifetime.
Order Information 500902 Rackmount Balun Chassis 6
8495 Dalton Road, Mount Royal, Quebec, Canada, H4T 1V5
Tel.: (+1) 514-905-0588 Fax: (+1) 514-905-0589
Toll Free (North America): (877) 689-5228
E-mail: [email protected] URL: www.muxlab.com
94-000657-A SE-000657-A
Rackmount Balun Chassis 6 (500902)
Installation Guide
Introduction
The Rackmount Balun Chassis 6 is designed as a head-end cable management
solution, allowing any combination of up to six (6) MuxLab square baluns to be
installed in a standard 19” telecom relay rack. Head-end AV equipment such as
DVD players, video servers and cable boxes may be installed in a local wiring
closet and connected to the Cat5E/6 structured cabling system via a wide array of
MuxLab balun solutions.
The baluns may be installed in either front or rear- facing orientation depending on
the application. At the display end, the appropriate MuxLab baluns are installed at
the receivers to support a fully Cat5E/6 cabling solution. Each balun snaps into
place and is held firmly by a spring latching mechanism. The product features a
rugged one-piece design for ease of installation and maintenance.
Installation
In order to install the Rackmount Balun Chassis 6 (500902), perform the following steps:
1. Identify the final location of the Rackmount Balun Chassis.
2. Install the Rackmount Balun Chassis in the 19” relay rack using the 10-32 rack
screws and nylon washers included with the product.
3. Install each balun in its appropriate slot. In order to install each balun, push the
balun into the desired slot from the rear of the Balun Chassis. The slots are
numbered “1” to “6”. Each balun snaps into place and is retained by a spring-steel
retaining clip.