Boombox na4, User manual, 2 – electrical – Attero Tech BoomBox NA4 User Manual
Page 8
BoomBox NA4
User Manual
Attero Tech LLC 2011-2013
Page 4
614-00006-02
2.2 – Electrical
Attach the speakers to be used to the appropriate outputs
When powering using PoE:
o
Attach the CobraNet I/F port to a spare PoE-enabled port on a PoE switch using a CAT-5 cable. If a midspan
injector is being used, connect a spare input port to the CobraNet network switch using a CAT-5 able, and
then connect the corresponding output port to the CobraNet I/F of the BoomBox
When powering using an optional external supply:
o
Attach the CobraNet I/F port to a spare port on the CobraNet network switch using a CAT-5 cable
o
Attach the power supply to the power input jack and then power up the external supply
If all steps are performed correctly, the power light on the front should be lit.
There may also be some activity on the BoomBox CobraNet I/F LED indicators. With no CobraNet network, the LED on
the right of the CobraNet I/F port will be on. If another active CobraNet device is detected on the network or the Attero
Tech Control Center application or other similar CobraNet application program is active on the network, the left hand
LED will be flashing at a rate around three times per second and the right hand LED will remain steady.