Attero Tech unDIO2x2 - Manual (Page 5)

unDIO2x2
User Manual
 Attero Tech LLC 2013 Page 4 614-00013-01
1 - Overview
The unDIO2x2 is a 2-in/2-out audio interface utilizing Audinate’s Dante protocol. It's ideal for adding 2 channels of
Dante audio I/O in a small, unobtrusive form factor. The two inputs use 3-pin depluggable connectors for balanced or
unbalanced I/O connectivity and support either mic or line level signals. Each input also features a 24V phantom power
option. The two outputs also use 3-pin depluggable connectors and each provides a balanced line level output. Each
output also has an optional +10dB analog boost.
Connection to the Dante network is provided by a single Ethernet RJ45 connector on the back of the unit.
The unDIO2x2 can be powered by a 12V DC wall wart (ordered separately) but it also supports the use of PoE instead.
This allows the unDIO2x2 to be powered over the network cable from a suitable PoE source (IEEE802.3af). The PoE
power option is particularly useful if the unDIO2x2 is mounted in a remote location where access to a mains outlet is
limited or indeed, non existent.
Audinate’s Dante Controller software is used to control the audio routing configuration of the device while the Attero
Tech unIFY Control Panel application can be used to configure the device-specific features, such as the mic/line
configuration, phantom power, and analog output boost.
Figure 1 - unDIO2x2 front and back
The unit comes in a small form factor with integrated mounting bracket allowing it to be mounted discretely in small
spaces (such as under desks) close to the sources or sinks thus reducing the amount of analog cabling that may be
required.
The unDIO2x2 can be controlled and monitored via with 3
rd party Control software via a proxy service. See the unIFY
Proxy Server Users Manual for more details.
1.1 – What’s in the Box
The unDIO2x2 comes supplied with the following
o unDIO2x2 device
1.2 – Optional Extras
All of the following are available as options for the unDIO2x2 that may be ordered separately:
o A 12 V DC power supply is available if PoE power is not required or available