Chemglass CG-15005-01 User Manual
Page 4
Advertising
4
Setup & Operation:
1. Connect the heater / heating mantle to the load receptacle (located on the rear of the unit).
2. Plug the power cord of the Power Controller into an electrical outlet.
3. Turn the ON/OFF switch to its ON position. In the ON position, the switch will be illuminated.
4. Now you’re ready to control your heater / heating mantle load. Turn the control knob to your desired power setting.
5. The heating mantle will now heat up.
6. When the knob is pointed at 100%, full power will be applied to the load. (Refer to Table 1)
Advertising