Chemglass CG-15006-20 - Manual (Page 4)

4
Setup & Operation:
1. Connect the heater / heating mantle to the load receptacle (located on the rear of the unit).
2. Plug the power cord of the Power Controller into an electrical outlet.
3. Turn the ON/OFF switch to its ON position. In the ON position, the switch will be illuminated.
4. Select either the 30 VAC or 60 VAC output.
5. Turn the control knob to your desired power setting.
6. When the knob is pointed at 100%, full power will be applied to the load. (Refer to Table 1)
NOTE: Do not exceed Wattage & Voltage Requirements
of Heating Mantle
REAR VIEW FRONT VIEW
30/60 VAC Controller
Power cord
Mantle
Power cord
120VAC
Receptacle
30/60 VAC
Power
Controller
120VAC
Receptacle
30/60 VAC Controller
Power cord 30/60 VAC
Power
Controller
Mantle
Power cord