Chemglass CLS-1445 Series Spinner Flasks - Manual (Page 4)

[4]
CLS-1445 Spinner Manual CG Life Sciences
Magnet Assembly Installation (refer to Figures 2 & 3):
Loosen the cap nut from the cap but do not completely remove. For easier
installation, moisten the glass shaft with water and gently slide it through the cap
assembly from the bottom through compression fitting body and then hand tighten
the cap nut loosely to hold the magnet assembly in place.
Place the entire assembly into the flask and adjust the height of the magnet by
sliding the glass shaft either up or down until the desired height is achieved (see
figure 3). Next tighten the cap nut to lock the magnet height.
Figure 2 Figure 3
WARNING: Be careful handling the glass shaft as accidental
breakage can cause injury
¼” to ½”
From
magnet
holder to
bottom
With magnet
assembly attached
(from Figure 1)