Chemglass CLS-1455 Series Spinner Flasks - Manual (Page 4)

[4]
CLS-1455 Spinner Manual CG Life Sciences
WARNING: Be careful handling the glass shaft as accidental
breakage can cause injury
Internal Cap Assembly (refer to Figures 2, 3, 4):
Place the white silicone gasket in the inside of the center screw cap and thread the
compression fitting body on to the cap stud. Next locate the impeller assembly and
cap nut, and then insert the end of the glass shaft in the cap nut and slide the o-
ring over the shaft. Next, loosely screw the cap nut with o-ring and glass shaft
(with attached impeller assembly) to the compression fitting body. Do not fully
hand tighten until the impeller assembly is adjusted to be about ¼ inch to ½ inch
from the bottom of the flask, then fully hand tighten (see figures 3 & 4).
Figure 2
¼” to ½”
From
impeller to
dimple
¼” to ½”
From
impeller to
bottom
Figure 3
Figure 4
CAP STUD
With Impeller
assembly
attached (from
Figure 1)