ConTech Lighting CF8 - Manual

INSTALLATION INSTRUCTIONS
For the Con-Tech Lighting Ceiling Mount Cylinder Fixtures
(CM6C, CM8C, CF6C, CF8C, CI6C, CI8C)
www.con-techlighting.com 1-800-728-0312 CYLINST_CM All specifications subject to change without notice.
IMPORTANT SAFETY INSTRUCTIONS:

Read all the instructions before installation. Save the instructions
for later use.

Turn off the power at the fuse or circuit breaker box before
installation or any maintenance work.

Wear rubber-soled shoes and work on a sturdy wooden or other
nonconductive ladder.

Fixtures must be installed according to national electrical code
and local building codes. For indoor use only.

To avoid a hazard to any children, account for all parts and
destroy all packing materials.

Do not install any fixtures closer than 6” from any curtain or
similar combustible material.

Warning: Risk of fire. Most dwellings built before 1985 have
supply wire rated at 60°C. Consult a qualified electrican before
installation.

Call the Technical Support department at Con-Tech Lighting if you
have any installation questions. 800.728.0312
CEILING MOUNT INSTALLATION INSTRUCTIONS
1. Detach the cylinder lid from the fixture by twisting the lid
counter-clockwise and pull it up. Figure 1.
2. Install the lid to the junction box with included screws. Figure 2.
3. Connect the cylinder wires and the input power wires from the
junction box (Black to Black, White to White, Green to Green)
with included wire nuts. Figure 2.
4. Attach the cylinder to the lid by twisting the cylinder
counter-clockwise until hearing a locking noise.
5. Attach the reflector by aligning the screws next to the socket
with the key-hole slots on the reflector. Turn the reflector so that
the screws slide over the narrow portion of the key-hole slots.
Tighten the screws with a Philips head screwdriver. Figure 3.
6. For baffle assembly, push the baffle into the reflector for a tight fit.
7. Insert the appropriate wattage lamp per the UL relamping label.
Cylinder Lid
Turn lid counter-clockwise,
pull up to detach
Install Cylinder lid
to junction box
Safety Chain
Connect cylinder wires to
power supply wires
Figure 1
Figure 2
Figure 3: View of Socket
Keyhole Slots
Philips Head Screws
Socket