APC NETBOTZ NBWL0455 - Manual (Page 21)

NetBotz 455 Installation and Quick Configuration Manual 17
• Microsoft
®
Windows
®
Systems: To install the applications and the JRE
on a computer running Windows XP SP1 or SP2, or Windows 2000,
place the NetBotz Appliance Utility CD in the CD drive of the computer
that you will use to configure and manage your appliance. The NetBotz
Installer starts automatically. If you have disabled Autorun on your
computer, click Start > Run, type x:\av\windows\install.exe
in the Open field (where x is the drive letter assigned to your CD drive)
and click OK. Follow the prompts to complete the installation of your
software.
• Linux Systems: To install the applications and the JRE on a computer
running Red Hat
®
Enterprise Linux
®
4 or Fedora™ Core 4 or later, place
the NetBotz Appliance Utility CD in the CD drive of the computer that
you will use to configure and manage your NetBotz appliance. Mount
the drive if necessary. Run install.bin from the Linux subdirectory
on the CD. For example, if you are using Linux and you mounted the CD
drive as /mnt/cdrom, execute the following command:
sh /mnt/cdrom/linux/install.bin
Follow the prompts to complete the installation of your software.
Configure network settings using the Serial Configuration Utility
To configure your appliance using the Serial Configuration Utility:
1. Click Start > Programs > APC > Serial Configuration > Serial
Configuration Utility to start the Serial Configuration Utility.
2. Connect one end of a USB cable to your computer and the other end of
the cable to the Console port on the NetBotz appliance.
3. Plug the power cord provided with your NetBotz appliance into a wall
outlet, and then connect it to the AC line inlet.
Note: This power cord is to be used only with APC NetBotz
products.
The green Power LED illuminates immediately after you apply power to
the appliance. The unit can take up to two minutes to initialize,
depending on appliance configuration. The red Alert LED illuminates
when the appliance detects an alert condition. Click Next to continue.
4. The Serial Configuration Utility automatically scans your system COM
ports to determine if an APC appliance is connected to the network. If an
APC appliance is discovered, the appliance is listed in the Device column
of the window. Select the radio button for the appliance to configure and
click Next to continue.