APC NETBOTZ NBWL0455 - Manual (Page 23)

NetBotz 455 Installation and Quick Configuration Manual 19
Install a wireless network device
You can install a third-party wireless network device by connecting it to the
Ethernet port on the appliance using an Ethernet cable. APC currently supports
the D-Link DWL-G820, a wireless Ethernet bridge.
To install and configure a third-party wireless network device, see
the instructions provided with that device.
The APC Configuration Wizard
Use the Configuration Wizard to configure the following settings on your
appliance:
• Domain Name Server Settings
• Clock and Calendar Settings
• Region Settings
• Administrator User ID and Password
• E-Mail Settings
• E-Mail Alert Notification Recipients
The Configuration Wizard downloads the latest available version of BotzWare
to your appliance.
When you finish configuring your appliance with the Wizard, your appliance
monitors your environment for lack of adequate air flow and for changes in
temperature and humidity and detects motion in the area in which the camera is
located. Alert conditions detected by any of these sensors generate an e-mail to
send to a specified e-mail address.
The Configuration Wizard runs each time you use the Advanced View with
your APC appliance until you complete all of the steps in the Wizard or check
Don’t Show Configuration Wizard Next Time. You can run the Wizard again
by selecting Configuration Wizard from the Advanced View Tools pull-down
menu.