ConTech Lighting LVR316 - Manual

2
INSTALLATION PROCEDURES
Do not install insulation within 3" of the housing. (Figure 1)
Cut the plastic retaining strap off the transformer/junction box mounting plate
assembly.
Remove the transformer/junction box on the mounting plate assembly from
the junction box.
Remove a knockout from the junction box for the supply wires before
mounting the transformer plate back on the junction box.
To mount the recessed fixture to the ceiling structure, extend the adjustable
bar hangers and firmly mount to the ceiling joist support members.
NOTE: When installing to a wood joist, the convenient mounting spikes may
be used to hold the hanger bars temporarily in place. The installation must be
completed with proper fasteners (not provided).
Screw or nail the bar hangers sercurely to the wood joists. T-Bar cutouts are
provided in the bar hangers.
ELECTRICAL CONNECTIONS
Connect the 3/8" or 1/2" size flexible conduit (black, white and green 120V
supply wires) to the junction box with a suitable connector.
Connect black to black (hot), white to white (neutral), and green to green
(ground) with twist type wire connectors (not provided). (Figure 2)
Replace the junction box cover by setting the plate base into the holder and
locking at the side with the spring clip. Ensure that all wires are safely within
box before closing.
Position the housing so that the rim is flush with the finished ceiling. The
recessed housing is adjustable vertically (held in place by [3] spring clips).
Place the tempered glass lens (supplied with the trim) into the lamp cradle
and properly seat the lamp between the spring retainer and the clear
tempered lens. NOTE: Handle the MR16 lamp only by the socket or rim.
Never touch the interior portion. If the electrician or designer decides to use a
front glass MR16 lamp, the standard clear tempered safety lens should not be
used. Use of both will cause excessive heating and void the factory warranty.
Firmly press the lamp pins or the lamp socket leads from the trim into the
two holes in the ceramic terminal block socket. Tighten the two straight
blade retaining screws in the ceramic terminal block socket. Tuck the
combined wire leads out of the way into the housing cavity.
Set the two or three trim mounting springs into the housing opening and push
up until the trim is seated firmly to the ceiling surface. After the trim is
inserted fully, give it a quarter turn to secure it into place.
NOTE: If the recessed housing is going to be controlled by a dimmer, only
use dimmers rated for low voltage magnetic transfomers.
IMPORTANT SAFETY INSTRUCTIONS:
• Read all the instructions before installation. Save instructions for later use.
• Turn off power at fuse or circuit breaker box before installation or before
doing any maintenance work.
• Product must be grounded to avoid potential electric shock and any other
potential hazards.
• Product must be mounted in locations and at heights and in a manner
consistent with its intended use, and in compliance with National Electrical
Code and local codes. Use of accessory equipment is not recommended.
• Installing contrary to instructions may cause unsafe conditions.
• Do not block light from the trim aperture, in whole or in part, as this may
cause unsafe conditions.
• Warning: Risk of fire. Most dwellings built before 1985 have supply wire
rated at 60°C. Consult a qualified electrician before installation.
• To avoid hazards to children, account for all parts and properly dispose of
all packing materials.
• Call the Technical Support department at Con-Tech Lighting with any
installation questions: 847.559.5500.
White to White
Black to Black
Ground Wire
LVR316 INST
For Con-Tech Lighting Low Voltage Recessed Housing: LVR316
www.con-techlighting.com
All specifications subject to change without notice.
1-847-559-5500 This document can be recycled.
JOIST: 2" x 8"
3" 3"
INSULATION
CEILING MATERIAL
3"