ConTech Lighting LVR316-IC - Manual

INSTALLATION PROCEDURES
• The wiring box will accept metal conduit or nonmetallic cable, but metal
conduit must be used if your electrical code requires it.
Metal Conduit: remove appropriate round pry-out(s) and connect conduit to
wiring box with proper connector(s) (not included).
Nonmetallic Cable: remove appropriate rectangular pry-out(s) on top of
wiring box and insert cable, pushing past the cable lock in wiring box. Cable
will be held in place by the lock; no other connector is required.
• Make electrical connections:
- Connect 1/2" trade size flexible conduit (supply wire) to junction box
opening near housing with sustainable housing.
- Connect black to black (hot), white to white (neutral), and green to green
(ground) with twist type wire connectors (not provided). (Figure 1)
- Connect output leads Molex plug from transformer to receptacle plug in
junction box.
- Replace cover. Ensure that all wires are safely within box before closing.
• This fixture is designed for use with 12V 50W MR16 type Halogen bulb. If a
lamp larger than 50W is used, the built-in thermal protector will cause the
lamp to blink on and off, indicating a potential over-heating situation. A
proper 50W MR16 lamp must then be utilized.
• Care should be taken in the handling of the 50W MR16 Halogen lamp; only
grasp by the rim or back of the lamp, never place bare fingers inside or touch
the encapsulation. The two contact pins of the lamp should be firmly set into
the two holes of the porcelain backed lamp holder (socket). NEVER ATTEMPT
TO PLUG A LAMP DIRECTLY INTO THE PLASTIC MOLEX CONNECTOR.
• This fixture is provided with a connector that acts as a disconnect to
remove socket assemble when using some of Con-Tech Lighting’s trim
models. This disconnect device may also be used in the event of any
required socket replacement. Care should be taken to ensure that the
connector housing does not come in contact with the high temperatures
of the lamp holder.
IMPORTANT SAFETY INSTRUCTIONS:
• Read all the instructions before installation. Save instructions for later use.
• Turn off power at fuse or circuit breaker box before installation or before
doing any maintenance work.
• Product must be grounded to avoid potential electric shock and any other
potential hazards.
• Product must be mounted in locations and at heights and in a manner
consistent with its intended use, and in compliance with National Electrical
Code and local codes. Use of accessory equipment is not recommended.
• Installing contrary to instructions may cause unsafe conditions.
• Do not block light from the trim aperture, in whole or in part, as this may
cause unsafe conditions.
• Warning: Risk of fire. Most dwellings built before 1985 have supply wire
rated at 60°C. Consult a qualified electrician before installation.
• To avoid hazards to children, account for all parts and properly dispose of
all packing materials.
• Call the Technical Support department at Con-Tech Lighting with any
installation questions: 847.559.5500.
LVR316IC INST
For Con-Tech Lighting Low Voltage IC Rated/StopAire® Housing: LVR316-IC
www.con-techlighting.com
All specifications subject to change without notice.
1-847-559-5500 This document can be recycled.
White to White
Black to Black
Ground Wire