A.O. Smith ST 3000 - Manual (Page 4)

1.4 Technical specifications
ST 1500/2000 ST 2500/3000
1 Storage capacity ltr
1500/2000 2500/3000
2 Tank heat loss kWh/24h
8.5 10.1
3 Maximum working pressure bar 7 7
4 Test pressure tank bar 12 12
5 Maximum allowed tank temperature °C
95 95
6 Weight empty kg 374/506 637/739
2. FOR THE INSTALLER
2.1 Installation
A qualified, competent installer must install the hot water storage tanks in accordance
with local valid regulations and codes.
Location needs to be chosen to prevent damage in case of tank leakage (e.g. place tank in
a drain pan or near a floor drain of sufficient capacity). For mounting of the jacket see
separate attached Kit installation sheet.
2.2 Water connections
The water heater is suitable for connection to vented, un-vented and pumped pressurized
systems. In each case appropriate valves and fittings should be used to ensure the system
complies with the governing codes and appropriate building requirements. The maximum
working pressure is 7 bars. A typical installation diagram for an un-vented installation is
as follows:
4