HES 2005M3 SMART Pac III - Manual (Page 2)

2
Installation Directions
1. Connecting the SMART Pac III: Connect the SMART Pac III to the wires coming from the
access control panel as shown on Page 3, using either the 12V or 24V pigtail provided with the
HES electric strike. If using other ASSA ABLOY electrified products, refer to the wiring schematic
on Page 4.
2. Using SMART Pac III to confirm correct input voltage: Set the SMART Pac’s slide switch to
the voltage of the power supply (see Page 3) and activate power. The behavior of the SMART
Pac’s LED Status Indicator will communicate the following:
 Voltage input, and if it is within the input requirements listed on Page 3
 Correct position of the the SMART Pac’s slide switch for the voltage input
3. Resolving Fault Codes: A blinking or unlit LED indicates corrective action is needed.
a. Using the LED STATUS INDICATOR TABLE below determine the appropriate
corrective action.
b. Remove power to the SMART Pac III and correct the error condition.
c. Wait 10 seconds and re-power the unit. This will reset the LED indicator.
Warning: The slide switch configures the wiring to the electric strike. It does not control the
SMART PAC III’s voltage output and will not prevent an overload condition if set improperly. The
voltage rating of the electric strike must match the voltage output of the power supply (e.g.: Use
a 24 Volt strike if you have a power supply rated at 24 Volts.)
If using an electric strike and/or additional devices in series with a single SMART PAC III, do not
exceed a current rating of 750 MA at 25 C.
4. Connecting the Electric Strike: With no power supplied to the SMART Pac III, connect the
electric strike. Verify the operation of the electric strike and a steady LED color when power is
present.
*See input requirements on Page 3
LED STATUS INDICATOR TABLE
NOTE: A self re-setting poly switch is built into the SMART Pac III to prevent damage to the
electric strike in an over-current situation or downstream short. Normally, the SMART Pac III will detect
over current situations and shut down the power output before the poly switch opens. If the poly switch
trips there will be no voltage output and no LED status.
LED COLOR INPUT CONDITION OUTPUT CONDITION
Steady Green 10.5-21V* 15 VDC MAX STEPPING TO 9 VDC
Steady Yellow 21-33V* 30 VDC MAX STEPPING TO 18 VDC
Blinking 2 Yellow/2Green ANY WRONG SLIDE SWITCH POSITION
Off or Blinking Green TOO LOW (min. 10.5V) ~ 0
Blinking Yellow TOO HIGH (>33V) ~ 0
Blinking Yellow/Green ANY DOWNSTREAM SHORT
1
2
3
4
5
6
CORRECTIVE ACTION
NONE REQUIRED
NONE REQUIRED
CHANGE SLIDE SWITCH POSITION
INCREASE VOLTAGE
DECREASE VOLTAGE
FIND AND REMOVE SHORT