Kramer Electronics tp-219hd - Manual (Page 10)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the TP-219HD and TP-220HD
8
Figure 4 and Table 4 define the TP-220HD underside panel:
Figure 4: TP-220HD (Underside Panel)
Table 4: TP-220HD (Underside Panel) Features
# Feature Function
1 HS Switch Slide the switch up
1
(to INVERTED) to invert the HS polarity
Slide the switch down (to NORMAL) to retain the polarity
2 VS Switch Slide the switch up
1
(to INVERTED) to invert the VS polarity
Slide the switch down (to NORMAL) to retain the polarity
5 Connecting the TP-219HD and TP-220HD
You can use the TP-219HD XGA/HD – Line Transmitter/Switcher with the
TP-220HD XGA/HD – Line Receiver/DA to configure an XGA/HD DA
system. This will let you transmit one selected computer graphics/HD signal
to two displays via long line CAT 5 UTP cabling.
To connect the TP-219HD to the TP-220HD, as the example in Figure 5
illustrates, do the following:
1. On the TP-219HD, connect
2
:
ƒ An XGA 3
source (for example, Computer Graphics Source 1) to
the INPUT 1 15-pin HD connector
ƒ An XGA 3
source (for example, Computer Graphics Source 2) to
the INPUT 2 15-pin HD connector
2. If necessary, set the HS and VS switches on the TP-219HD underside
4
.
1 By default, both switches are set to NORMAL
2 You do not have to connect both inputs
3 Alternatively, you can connect an HD source, see section 5.1
4 By default, both switches are set to normal (see Figure 2 and Table 2 )