Kramer Electronics SID-X1N - Manual (Page 10)

6 SID-X1N - Defining the SID-X1N Step-in Commander
Figure 2 defines the rear panel of the SID-X1N.
Figure 2: SID-X1N Step-in Commander Rear Panel
# Feature Function
1 AUDIO OUT 3.5mm Mini Jack Connect to an unbalanced, stereo audio acceptor, (see
Section 4 )
2 TP OUT RJ-45 Connector Connect to a compatible switcher or DGKat receiver, (for
example, VP-81SIDN or PT-572+) using CAT 6 or higher
specification cable
3 REMOTE STEP-IN
3-pin Terminal
Block LED Connect to the anode of the remote Step-In LED indicator
4 Switch Connect to the remote, Step-In switch, (see Section 5.1 )
5 PROG RS-232 3-pin Terminal
Block Connect to the PC via RS-232 to perform a firmware upgrade
6
REMOTE
SELECT 8-pin
Terminal Block
LED Connect to the anode of the remote Input Select LED indicator,
(see
Section 4 )
7 Switch Connect to the remote, Input Select switch, (see Section 5.2 )
8 LED HDMI,
DP, DVI
and UXGA Connect to the anodes of the remote input indicators
(see
Section 5.3 )
9 OPTION 8-way DIP-switch Used to set the device behavior, (see Section 8.1 )
10 12V DC Power Connector Connect to supplied power adapter, center pin positive