Kramer Electronics RC-76M - Manual (Page 12)

RC-76M/ RC-712M - Installing the RC-76M/RC-712M 9
Pass the appropriate cables through any of the four housing cable
pass-through openings on the sides of the box (see Figure 3 ).
Figure 3: Merten Compatible Housing
Always switch off the power to each device before connecting it to your
RC-76M/RC-712M. After connecting your RC-76M/RC-712M, connect
its power and then switch on the power to each device.
Although the illustration in Figure 4 shows the RC-712M, the following example
applies also to the RC-76M.
To connect the RC-76M/RC-712M as illustrated in the example in Figure 4 :
1. Connect the IR outputs as follows:
 Connect an IR emitter to IR OUTPUT 1 and attach the emitter to the
DVD player 1

Connect an IR emitter to IR OUTPUT 2 and attach the emitter to the
DVD player 2
2. Connect the RS-232 ports (see Section
4.2.1.1
) as follows:
 Connect RS-232 port 1 to the projector
 Connect RS-232 port 2 to the plasma display
i
i