Kramer Electronics SL-1 - Manual (Page 9)

Connecting the SL-1 Master Room Controller
7
7
5.2 Connecting the Ethernet Port
The Ethernet connection of the SL-1 allows you to perform all control
functions of the SL-1 over the Internet using a PC running the Kramer
Site-CTRL control program.
To connect the SL-1 to a network:
1. Connect the Ethernet port of the SL-1 to the Ethernet port on a network hub
or network router, via a straight cable with RJ-45 connectors.
2. At the other end, connect the Internet to a PC running Site-CTRL.
After connecting the Ethernet port, you have to install and configure it. For
detailed instructions on how to install and configure your Ethernet port, see
the K-Config Configuration Guide
1
5.3 Connecting the K-NET Port
.
The K-NET port is wired as shown in Figure 4 .
Figure 4: K-NET Pinout Connection
1 Available for download at the Kramer Web site: www.kramerelectronics.com