Kramer Electronics FC-340 - Manual (Page 19)

16
FC-340 - Operating the FC-340
7.2.4 Comm Settings Sub-menu
The parameters in the Comm Settings sub-menu set the network IP and display
the serial communications values.
Parameter Description Options
NETWORK IP address Sets the IP network address Any valid IP address
Default
—192.168.001.039
IP mask Sets the IP network mask Any valid subnet
Default
—255.255.000.000
IP gateway Sets the IP gateway address Any valid gateway address
Default —000.000.000.000
IP port Sets the IP port number Any valid TCP port
Default
—05000
RS-232 Baud Displays the baud rate 115200
Parity Displays the parity bit setting none
7.2.5 System Sub-menu
The parameters in the System sub-menu display the device versions and set the
LCD display characteristics.
Parameter Description
FIRMWARE The device firmware version
FPGA VER The device FPGA version
S/N The device serial number
7.3 Resetting the Device to Factory Default Configuration
To reset the device to the factory default configuration:
1. Turn the device off.
2. Press and hold the Reset button on the rear panel of the device.
3. While holding the button depressed, turn the device on.
4. Hold the button depressed for 10 seconds and release the button.
The configuration is reset to the factory default.