AstroStart 903 - Manual (Page 8)

6
CONTINUOUS MODE |
The “Continuous Mode“ function allows to remove the key from the ignition while leaving the engine running. This convenient
feature allows you to leave the vehicle for short periods of time while the climate controls remain on.
A UTOMATIC
TRANSMISSION
VEHICLES
To access Continuous Mode, send start command
(Model 801 - 2101 - Model 903 ) while engine is idling.
Parking lights, engine and preset accessories will remain on
for the duration of the programmed runtime.
M ANUAL
TRANSMISSION
VEHICLES
To access Continuous Mode, send start command (Model 801 - 2101 - Model 903 )
before removing the key from ignition when performing the safety sequence described on page 3.
Note: Do not send the STOP command if you perform sequence
activated by the remote control (Step 7).
Remove key, exit vehicle and lock doors. All safety devices will remain active.
If you return to your vehicle before runtime has elapsed, just turn the key to the RUN position and depress brake pedal.
W HAT STOPS THE ENGINE
For your safety, engine will not start or will stop if:
ignition switch is in the RUN position (prevents starting);
remote control sends a Stop message;
hood is open;
brakes are applied;
engine is over-revving (programmable Enable/Disable at time of installation);
main switch is OFF;
safety sequence not valid (manual transmission vehicle only - parking brake not applied, opening of door detected
while remote starter was not keeping engine running).
M AIN SWITCH
The main switch is usually mounted under the dashboard. It is a toggle ON/OFF
switch that is used to cancel start functions.
It does not disable other commands which remain active (lock/unlock commands, etc.).
STOP (903)
When engine is kept running by Remote Starter, you can stop it by pressing:
Option 1 • button (lights: 1).
Option 2 • and simultaneously (lights: 1).
Engine and parking lights will shut down.
This command also terminates panic mode.