Sunlight Supply Titan Controls® Helios® 7 - 8 Light 240V Controller with Timer - Manual

Instructions for Use
1. Must be installed by a certifi ed electrician.
2. Connect 240 volt power to the 3 screws under the protective
cover. (See ‘Instructions for Operation’ section).
3. Replace protective cover with screws provided.
4. Securely mount your Helios 7, with hardware provided, near
the ballasts to be operated. It should be placed away from
water, mist, spray, etc.
5. Plug your 240 volt ballasts into the multi-tap outlets on the
left and right side of the controller.
6. Adjust the analog timer to the current time of day. Set your
timing pattern by pushing the ‘time trippers’ towards the
center of the dial.
7. Your Helios 7 will now control your ballasts at the desired
settings until the power is defeated.
Helios 7
TM
8 Light - 240 Volt Lighting Controller
Easy Guide
VANCOUVER, W ASHINGTON U.S.A.
®
Controller Specifi cations
Size: 13"H x 11"W x 4"D
Weight: 10 lbs.
Voltage Input: 240 volts
Voltage Output: 240 volts
Maximum Amperage: 40 amps
Maximum Wattage: 8000 Watts
Hertz: 60 Hz
Time Switch: 24 hour analog timer
Operating Temperature: 40 ° to 125° F | 5° to 52° C
Storage Temperature: 32 ° to 135° F | 0° to 57° C
to 50 Amp
Power Source
to 240 Volt Ballast
to 240 Volt Ballast
Helios 7
240 Volt
Sun System R
Sun System R
to 240 Volt Ballast
to 240 Volt Ballast
to 240 Volt Ballast
to 240 Volt Ballast
to 240 Volt Ballast
Sun System R
to 240 Volt Ballast
Sun System R
24 HR Timer
Sun System R
Sun System R
Sun System R
Sun System R
Wiring
diagram
Hot Neutral Hot Ground
Controlling a light bank
®
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.