WeatherTech Side Window Deflectors - Manual (Page 4)

12 13
14 15
Tips for proper fit
*Ensure that the only part of the deflector insterted into the window channel is the thin, machined flange along the
edge of the deflector.
*The bottom edge of the front deflector must must be resting on the door’s outer weatherstrip molding. See inset
of figure 5.
*Check that the thin, machined flange of each deflector is fully and evenly inserted into the window channel. The
deflector flange is designed to rest in the main window channel between the window glass and the rubber seal.
*For windows with automatic raising feature: Roll the window all the way up without activiating the automatic
feature. Leave the window all the way up for at least 12 hours. The automatic raising feature should now function
properly.
*If windows are equipped with a safety feature that automatically opens the window if any resistance is met, sim-
ply sandwich the window with your hands and push upward while raising the window. This should allow the
window to close fully. Leaving the window in the closed position for 12 hours will ensure proper functionality.
*View our installation video on line at www.WeatherTech.com/install
5X Carefully and Slowly!!
Be sure to remove
adhesive backing
before installation
if supplied!
Carefully pull
outward to seat
the deflector.
Slide upward into
place, then gently
pull outward to
seat the deflector.
Asegúrese de quitar el forro adhesivo antes de la insta-
lación, si es provisto.
Tire suavamente hacia afuera para sentar el deflector.
¡Cuidadosa y lentamente! Deslice hacia arriba para acomodarlo en su lugar, después
tire suavemente hacia afuera para sentar el deflector.