Aiwa AV-NW30 - Manual (Page 12)

En
ENGLISH
12
RADIO RECEPTION
PRESET TUNING
You can preset up to 32 stations and tune them in directly.
PRESETTING STATIONS
1 Tune in the desired station.
2 Press ENTER to store the station.
The preset number, beginning from “ 1 ” appears on the display.
3 Repeat steps 1 and 2 to store other stations.
The next station will not be stored if a total of 32 preset stations
have already been stored. (“
FULL ” is displayed.)
TUNING IN PRESET STATIONS
1 Turn FUNCTION to select FM or AM.
2 Turn MULTI JOG to select a preset number.
Alternatively, press i or k on the remote control.
You can tune in the desired preset station directly by pressing
the numbered buttons on the remote control.
- To select preset number 11, press +10 and 1.
- To select preset number 25, press +10, +10 and 5.
To clear a preset station
1 Tune in the station by preset tuning.
2 Press ENTER, and press ENTER again while the frequency
flashes on the display.
Alternatively, press ENTER or C on the remote control, and
press ENTER while the frequency flashes on the display.
MANUAL TUNING
MULTI JOG
TUNER
MODE
0-9,+10
C
SHIFT
FUNCTION
ENTER
TUNING
INPUT MODE
POWER 6 STANDBY/ON
i / k / j / l
ENTER
1 Turn FUNCTION to select the desired band; FM
or AM.
2 Press TUNING N N N N N / M M M M M to tune in a station.
Alternatively, press j or l on the remote control.
“ TUNE ” is displayed when a station is tuned in.
“ 1 ” is displayed for FM stereo reception.
To search for a station automatically (Auto search)
Hold down TUNING N or M (or j or l ).
The unit searches for a station and stops at reception.
To stop the search manually, press TUNING
N or M (or j or
l ).
• Auto search may not stop at stations with weak signals.
When an FM stereo broadcast contains noise
Hold down SHIFT and press TUNER MODE on the remote control
so that “
MONO ” is displayed.
Noise is reduced, although reception is monaural.
To cancel, repeat the above so that “
STEREO ” is displayed.
When the reception contains noise interference
Move the unit away from other electrical appliances, especially
digital audio devices, or turn off the appliances that generate
noise signals.
To switch the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Hold down INPUT MODE and press POWER
6 STANDBY/ON.
To reset the interval, repeat this procedure.
NOTE
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
RADIO RECEPTION