Algolith C3012-8001-200 - Manual (Page 28)

Flea
28
Tr
oubleshooting
Troubleshooting
Please read the following troubleshooting section carefully before calling Algolith’s
support lines.
Television screen is blank:
1- Is the Flea on?
Source signals go through the Flea. When the Flea is off (power supply not connected), no
picture can reach the display device.
2- Is a valid input selected?
Selecting a vacant input (ex. no signal present at component input) will leave the screen
blank. Use the On Screen Display (OSD) to select a valid input (see Input on page 7 and
11).
3- Do you have the right connection?
A S-Video cable between the Flea and the display device will not carry the signal from a
component cable between the source and the Flea. (See Video Connections on page 7-8).
OSD menus appear small on screen:
1- It is normal for On Screen Display menus to appear in different sizes.
A 480i/p source signal will produce a large On Screen Display whereas a 1080i source will
produce a small On Screen Display.
Sound does not correspond to image:
1- The Flea does not have audio processing.
When 2 video sources are connected to Flea, switching from one to the other will
necessitate external audio switching.
Moving portions of the image create a blurry trail:
1- 3D Filtering is set too high.
When 3D Temporal Filter is set too high, it can create a blurry trail and cause a loss in
image details. Reduce 3D filtering strength. (See 3D Temporal Filter on page 17).