WIKA CS4L - Manual (Page 9)

Operating Instructions Temperature Indicating Controller CS4H / CS4L
V1.1 • 05/2006 - 9 -
Keys:
(12)
▲
: Increase key
Increases numeric value of the setting value.
(13)
▼
: Decrease key
Decreases numeric value of the setting value.
(14) MODE: Mode key
Switches the setting mode and registers the setting value and selected value.
(Setting value and selected value are registered by pressing the mode key.)
(15) OUT /
OFF
: OUT /
OFF
key
• When OUT /
OFF
function is selected in the OUT /
OFF
key function selection, control output can be turned on or
off. By pressing OUT /
OFF
key for approx. 1 second from any mode, control output OFF function works.
Once the control output OFF function is enabled, the function cannot be released even if the power to
the instrument is turned OFF and ON again. Control output OFF function keeps working. To cancel the
function, press the
OUT /
OFF
key again for approx. 1 second.
• When Auto/Manual control function is selected in the OUT /
OFF
key function selection, automatic control
starts when the power to the controller is turned on. If the OUT /
OFF
key is pressed again in this status,
manual control starts. If the OUT /
OFF
key is pressed again during manual control, the control reverts to
automatic one. However, Auto/Manual function can be switched only in the PV/SV display mode.
Notice
When setting the specifications and functions of this controller, connect the terminals 2 and 3
for power source first, then set them referring to “5. Setup” before performing “3. Mounting to
control panel” and “4. Wiring connection”.