Antennas Direct C2-CJM - Manual

Quick Start Assembly/Installation Instructions
CLEARSTREAM 2 ™ WITH MOUNT
Before attaching the antenna to any surface, TEST RECEPTION in that area.
Connect the antenna to the TV or receiver and run a full channel scan.
If reception is not as desired, move the antenna and rescan TV/receiver.
1
2
3
4
5
6
7
8
9
10
Indoor Wall / Outdoor Roof Mount
Tools Required: Adjustable Wrench, Power Drill, 5/16” Drill Bit,
Medium-sized Cross Point Screwdriver.
Thread coaxial cable
through reflector (1)
then hole in loop
element base (2) and
connect cable to
connector on back of
loop element (3).
Secure reflector, base
and loop together with
3 ½” bolt.
4
5
Place mast (4) into middle
of mast base (5) and
secure with 2 hex bolts.
4
2) Loop Element Base
3) Loop Element
4) J Mount Mast
5) Mast Base
6) Hex Bolts
7) 3 ½” Bolt
8) Expansion
Mounting Bolts
9) Weather Boot
10) J-mount Mast
End Cap
Call Our HELP LINE at 877-825-5572
One of our specialists can talk you through
any problems you may have.
Install antenna on mast
(4) by positioning clamp
on to mast. Install wing
nuts but do not tighten
them completely.
Mark mast base
position on your
surface. Adjust mast so
it is vertical and tighten
nuts. Drill a 5/16” hole,
1½ inches deep for
each mounting bolt.
Insert expansion bolts
and tap into position.
Place base over
mounting bolts, then
tighten nuts to secure
bolts and base to your
surface.
Point antenna in
direction of your TV
stations’ transmission
towers, (to locate your
towers, go to
www.antennapoint.com
or contact your local TV
stations.) Perform channel scan and check reception.
NOTE: For outside installation, we have included a weather
boot (9), which can be cut to cable connector size.
1 2
3 4
4
Before beginning assembly, make sure all pieces needed are present.
3
1
2