19 ethernet configuration, 1 100base-t connector (cn1), 2 network boot – Advantech PCM-9570/S 2006957006 5th Edition User Manual
Page 40: 3 lan controller power select (j12), Table 2-13: lan controller power select (j12)
28
PCM-9570/S User's Manual
2.19 Ethernet configuration
The PCM-9570/S is equipped with a high performance 32-bit PCI-bus
Ethernet interface which is fully compliant with IEEE 802.3U
10/100Mbps CSMA/CD standards. It is supported by all major
network operating systems.
The medium type can be configured via the RSET8139.EXE program
included on the utility disk. (See Chapter 3 for detailed information.)
2.19.1 100Base-T connector (CN1)
100Base-T connects to the PCM-9570/S via an adapter cable to a
10-pin polarized header (CN1). For 10Base-T RJ-45 operation, an
adapter cable converting CN1 into a standard RJ-45 jack is required.
2.19.2 Network boot
The Network Boot feature can be utilized by incorporating the Boot
ROM image files for the appropriate network operating system. The
Boot ROM BIOS files are on the included utility disk.
2.19.3 LAN controller power select (J12)
Table 2-13: LAN controller power select (J12)
+5 V*
Standby 5 V
*default setting
Note:
PCM-9570/S supports wake-on LAN. For wake-on
LAN, J12 has to select standby 5 V (2-3) position.
3
2
1
3
2
1