Cirrus Logic AN271 User Manual
Cirrus Logic Hardware
Copyright
© Cirrus Logic, Inc. 2007
(All Rights Reserved)
http://www.cirrus.com
AN271
Cirrus Seismic Evaluation GUI Installation Guide
Cirrus Seismic Evaluation GUI (graphical user interface) is a generic tool controlling Cirrus Seismic Eval-
uation boards through a USB interface. The GUI can be obtained from
1. GUI Installation
1)
Go to the Cirrus Industrial Software download web site
2)
Click the link, “Cirrus Seismic Evaluation GUI Vxx” (xx indicates version number).
3)
Download the file named SeismicEvalGUI_Vxx.zip onto the PC and unzip it. A folder structure called
“Distribution\Volume1” will be created (for example, C:\Distribution\Volume1)
4)
Open the folder and run the setup.exe file (C:\Distribution\Volume1\setup.exe).
5)
If the GUI has been installed previously, the Uninstall wizard will remove the older version (see below).
6)
Follow the instructions presented by the Cirrus Seismic Evaluation Installation Wizard.
7)
To run the GUI, go to:
Start
B
Programs
B
Cirrus Seismic Evaluation
B
Cirrus Seismic Evaluation
JAN ‘07
AN271REV3
Document Outline
- 1. GUI Installation
- 2) Click the link, “Cirrus Seismic Evaluation GUI Vxx” (xx indicates version number).
- 3) Download the file named SeismicEvalGUI_Vxx.zip onto the PC and unzip it. A folder structure ca...
- 4) Open the folder and run the setup.exe file (C:\Distribution\Volume1\setup.exe).
- 5) If the GUI has been installed previously, the Uninstall wizard will remove the older version (...
- 6) Follow the instructions presented by the Cirrus Seismic Evaluation Installation Wizard.
- 7) To run the GUI, go to:
- 2) Apply power to the target board.
- 3) The PC will detect the target as an unknown device. Using the Windows® Device Manager, go to t...
- 4) Select Install from a list or specific location then click Next.
- 5) Select Include this location in the search and click the Browse button.
- 6) Select the driver directory under C:\Program Files\Cirrus Seismic Evaluation\, then click OK.
- 7) The PC will install the USBXpress Device driver.
- 8) After installation, cycle the power to the target board.
- 9) The PC should add the USBXpress Device under Universal Serial Bus controllers in Windows Devic...
- 10) To run the GUI, go to: