CPI Communications S V100 - Manual (Page 3)

3
type mobile however, the SV100 can be interfaced to almost any model of conventional of radio.
When used with the Maxtrac / Radius type mobile, the accessory connector should be programmed as
follows:
PIN FUNCTION DIRECTION DEBOUNCE ACT LEVEL
4 Null Output N Low
8 PL/DPL & CSQ DET Output N Low
9 Null Input N Low
12 Null Input N Low
14 Mic Off Hook Input Y Low
Warranty
CPI Communications, Inc. warrants each product manufactured by it to be free from defective material and workman-
ship and agrees to remedy any such defects or to furnish a new part in exchange for any part of any unit of its manufac-
ture which under normal installation use or service discloses such defects, provided the unit is delivered by the cus-
tomer to our authorized service center intact, with all transportation charges pre paid within two years from date of
shipment to the original purchaser. Exceptions are semiconductors which carry only the manufacturer's standard
warranty and lamp indicators and fuses which are warranted to be operational when shipped from the factory. No credit
will be given for unauthorized repair.
This warranty does not extend to any of our products which have been subjected to misuse, neglect, accident, incorrect
wiring not our own, improper installation, or to use in violation of instructions furnished by us nor extended to units
which have been repaired or altered outside of our factory or authorized service center, nor to cases where the serial
number thereof has been removed, defaced, or changed, nor to accessories used therewith not of our own manufacture,
nor to finish or appearance items.
This warranty is in lieu of all other warranties expressed or implied and no person is authorized to assume for us any
other liability in connection with the sale of our products.
Please Note: CPI products are not authorized for use in applications where nonperformance may be life threatening, or
where substantial risk to life and property may be present, without express written consent of the president of CPI
Communications, Inc. CPI Communications, Inc. shall never be liable for consequential or indirect damages.
4
8 7 6 5
3 2 1
RX AUDIO
GND
HOOK LINE
VRS *
MIC HI
VRS *
No Connection
PTT
Rear Panel View
J1
Below is a pin-out of the SV100 to radio connection for use in interfacing to other radios.
* - VRS = Valid Receive Signal. This must be a signal from your radio that indicates the presence of an RX
signal
with the proper PL or DPL present.
If the line used indicates only that an RX signal is present with out regard for a valid PL or DPL, then any
signal received by the mobile will be retransmitted by the satellite radio!
Please be aware that there are licensing issues involved in the use of radio equipment. You, as the user are
responsible for obtaining the proper license.