Avalon Stoves Seattle E User Manual

Sterling™ fireplace cabinets, Installation without a fireplace cabinet

Advertising
background image

C

M

Y

CM

MY

CY CMY

K

Visit us online:

www.avalonfirestyle.com

We reserve the right to improve our products at any time without prior notification.

Photos and illustrations are for descriptive purposes only. Copyright ©2007 T. I. - Printed in the USA

#98800137

11 3/4”

31 7/8”

26 3/4”

110 Volt

Wall Outlet

Unit must
slide out for
service

You have two ways to finish the installation of your Seattle Electric fireplace within your home. You can use one of our fireplace
cabinet systems. Or you can build it into an existing wall or chase and sheetrock up to the face, then finish it off like a traditional
fireplace with a mantel and stone or tile.

A 15 AMP, 110 VOLT wall outlet is
required. A dedicated circuit is
preferred but not essential in all cases.

Sterling™

Walnut Finished

Fireplace

Cabinet

Sterling™

Oak Finished

Fireplace

Cabinet

If you want a flush-to-the wall look for your fireplace, you have the option of building in or framing around your Seattle E Fireplace.
When framing the Seattle E enclosure, you must use the following
MINIMUM internal opening dimensions shown to the right.

CAUTION
Clearance for air circulation beneath the fireplace is critical. DO NOT INSTALL THE
FIREPLACE DIRECTLY ON CARPET OR SIMILAR SURFACES WHICH MAY
RESTRICT AIR CIRCULATION.

Sterling™ Fireplace Cabinets

If you are looking for exceptional value, add one of our Sterling fireplace cabinet systems and you can have your new Seattle Electric
fireplace installed in less than one hour! These fireplace cabinets allow the fireplace to be installed against any wall in your home.
Fireplace cabinets make it easy to relocate your fireplace at any time. Take the beauty and heat to other rooms, or take it with you
when you move.

Installation Without A Fireplace Cabinet

The electric fireplace must be able to slide out for service. You must also provide a
standard 15 AMP - 110 Volt wall outlet, preferably on its own breaker, within the
enclosure to allow the fireplace to be plugged in. The enclosure must allow the fireplace
to easily be removed for service. The fireplace cannot be hardwired.

Photo shows the bronze powder coated
Tree of Life face with the optional walnut
finished fireplace mantel.

Sterling™ Fireplace
Cabinet Dimensions:
52 5/8” Wide
43” High
17 1/2” Deep

Advertising