Hogtunes NCA 450U Kit-RM : 4 Channel Amplifier / Speakers (2014 - model year) - Manual (Page 5)

5
362R-RM ReaR SpeakeR
InStallatIon InStRuctIonS
Step #1: Remove the factory speaker grills by undoing the four screws on the front
of the grills. Carefully lift up on each speaker and take the two wires off
by pulling one at a time from the stock speaker. Remove the speakers.
Step #2: Hogtunes 362R-RM rear speakers are a direct replacement for the
OE speakers. The female OE “in-line” connectors mate with the male
connectors on each speaker and only go on one way. The #1 reason
for tech support calls is due to loose connections at the speaker. Please
make sure you have a very good connection to avoid this. Once you
are confident the factory wires are correctly attached to the new speak-
ers, set them in place, install the grills that came with the kit and secure
the speaker by re-installing the four screws per grill. NOTE: The factory
rubber “nutserts” on the rear pod side can be finicky. It’s a good idea to
get all four grill screws “started” and then get each one snug. Gradually
tighten each one down making sure all four screws holding
the grill down are secure!