HornBlasters HB4H5G40 - Manual (Page 2)

1
HornBlasters
Five Gallon Conductor’s Special
Installation Guide
Support Line: +1 (813) 783-8058
Fax Line: +1 (813) 783-2407
[email protected]
www.hornblasters.com/support
Before Getting Started
Read over the entire instruction guide before you begin your installation.
Kit Contents:
• HornBlasters Conductor’s Horns
• ViAir 400C Air Compressor Pump
• ViAir Weather-proof Pressure Switch
• Firestone 5 Gallon 7 Port Air Tank
• Electric Solenoid Valve
• Fittings, Air Line, Wiring Kit, Replacement Air Filters
IMPORTANT: This complete train horn kit uses 12 volt DC components. Only install this kit
with a 12 volt DC power source.
Important Safety Instructions
CAUTION: To prevent the risk of electrical shock or electrocution:
• Do not disassemble any electrical components of this horn kit (air compressor, air valve, pressure switch).
Do not attempt repairs or modifications of any component. Please refer to qualified service agencies for
all service and repairs.
• Do not operate any component where it can fall or be submerged into water or any kind of liquid.
• Do not reach for any component that has fallen or been submerged into water or any kind of liquid.
• Use the included components with 12 volt DC systems only.
• Do not leave the air system unattended during use.
WARNING: To prevent injury:
• Never allow children to operate the compressor or air horn. Use close supervision when operating this
equipment near children.
• The air compressor will become very HOT during and immediately after operation. Do not touch any part
of this compressor with your bare hands during or immediately after use.
• Do not use this product near open flames or explosive materials or where aerosol products are being used.
• Do not operate this product where oxygen is being administered.
• Do not pump anything other than atmospheric air.
• Never use this product while sleepy or drowsy.
• Do not use any tools or attachments with the supplied air source unit without first determining maximum
air pressure for that tool or attachment.
• Never point any air nozzle or air sprayer toward another person or any part of your body.
• The included air compressor is equipped with an automatic reset thermal protector and can automatically
restart after the thermal protector resets. Always cut off power source when thermal protector becomes
activated.
• Use only in well ventilated areas.
• Do not sound the air horn(s) in close proximity to another person’s or your own ear(s).
• Do not fill the included air tank above 150 PSI. Doing so may result in death or serious injury.
Safety During Installation
• Disconnect the ground of your battery before beginning your installation.
• Use eye protection when operating drills.
• Take your time and do not rush your installation.