Avital AVISTART 3001 - Manual (Page 10)

User-Programmable Features
All AviStart system and remote control programmable features are
accomplished by turning the ignition key "ON" (or starting the engine) and
flicking the valet switch on and off a preset number of times.
The AviStart also allows you to add new remote controls in one step, delete
lost or stolen remote controls or rearrange the factory preset remote control
functions.
1 . Remove the system from Protected Valet Mode. Programming cannot be
accessed while the system is in Protected Valet Mode.
2 . Select the feature you wish to program from the "Programming Table for
System Features" or the "Programming Table for Remote Controls" on
page 9. Note the number of beeps associated with that feature.
3 . Turn the ignition key to the "ON" position.
4 . Within 10 seconds, begin flicking the valet switch on and off. The piezo
beeper will beep once each time you flick the switch on then off.
5 . Continue flicking the switch on and off, counting the number of beeps.
NOTE: Stop when you reach the number of beeps associated with your
chosen feature.
6 . Follow the "Secondary Action." You will hear a number of beeps to
confirm that you have changed the setting of that feature.
7 . Turn the ignition key to the "OFF" position.
8 . Repeat steps 1-7 for any other feature you wish to program.
8
AviStart 3001 Owner's Manual