MSI 760GM-P34 (FX) - Manual (Page 21)

2
MS-7641
JCi: Chassis intrusion Connector
this connector connects to the chassis intrusion switch cable. if the computer
case is opened, the chassis intrusion mechanism will be activated. the system
will record this intrusion and a warning message will flash on screen. to clear the
warning, you must enter the BioS utility and clear the record.
1.CIN
TRU
2.Gro
und
JLPt: Parallel Port header
this connector is used to connect an optional parallel port bracket. the parallel
port is a standard printer port that supports enhanced Parallel Port (ePP) and
extended Capabilities Parallel Port (eCP) mode.
10.G
roun
d
14.G
roun
d
8.LP
T_S
LIN#
12.G
roun
d
6.PIN
IT#
4.ER
R#
2.AF
D#
24.G
roun
d
22.G
roun
d
26.N
o Pin
20.G
roun
d
18.G
roun
d
16.G
roun
d
1.RS
TB#
3.PR
ND0
5.PR
ND1
7.PR
ND2
9.PR
ND3
11.P
RND
4
13.P
RND
5
15.P
RND
6
17.P
RND
7
19.A
CK#
21.B
USY
23.P
E
25.S
LCT
JBAt: Clear CMoS Jumper
there is CMoS rAM onboard that is external powered from a battery located on
the mainboard to save system configuration data. With the CMoS rAM, the sys-
tem can automatically boot into the operating system (oS) every time it is turned
on. if you want to clear the system configuration, set the jumpers to clear the
CMoS rAM.
JBAt
keep data Clear data
1 1
iMPortANt
you can clear the CMoS rAM by shorting this jumper while the system is off.
Afterwards, open the jumper . do not clear the CMoS rAM while the system is on
because it will damage the mainboard.