MSI RS480M2 - Manual (Page 48)

3-17
BIOS Setup
Init Display First
This setting specifies which VGA card is your primary graphics adapter.
Sur roundv iew
SURROUNDVIEW
™ provides the power and convenience of multi-adapter, multi-
monitor support for computers that use an AGP- or PCI Express ® -based graphics
card in conjunction with ATI integrated graphics processors (IGPs). Setting options:
[Enabled], [Disabled].
USB EHCI Controller
This setting disables/enables the USB EHCI controller. The Enhanced Host Controller
Interface (EHCI) specification describes the register-level interface for a Host Con-
troller for the Universal Serial Bus (USB) Revision 2.0. Setting options: [Enabled],
[Disabled].
OnChip USB Controller
This setting disables/enables the onchip USB controller. Setting options: [Enabled],
[Disabled].
USB Keyboard
Set to [Enabled] if you need to use a USB keyboard in the operating system that does
not support or does not have any USB driver installed, such as DOS and SCO Unix.
Settings: [Auto], [Enabled], [Disabled].
USB M ouse
Set to [Enabled] if you need to use a USB mouse in the operating system that does not
support or does not have any USB driver installed, such as DOS and SCO Unix.
Settings: [Auto], [Enabled], [Disabled].
Onboard LAN
This setting allows you to enable/disable the onboard LAN controller. Setting options:
[Enabled], [Disabled].
Onboard 1394
This setting allows you to enable/disable the onboard IEEE 1394 controller. Setting
options: [Enabled], [Disabled].
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/
write. If your IDE hard drive supports block mode (most new drives do), select
[Enabled] for automatic detection of the optimal number of block read/writes per
sector the drive can support. Settings: [Enabled], [Disabled].
Onboard LAN Boot ROM
This setting enables/disables the initialization of the onboard LAN Boot ROM during
bootup. Selecting [Disabled] will speed up the boot process.