MSI X2-109 v1 - Manual (Page 43)

Configuring Arrays and Logical Drives 3-9
Version 2.0 Copyright © 2006 by LSI Logic Corporation. All rights reserved.
A graph shows the progress of the initialization until it is complete.
5. After the initialization is complete, press Esc to return to previous
menus.
If you press Esc while initialization is in progress, the following
options appear:
– Stop: (Available only if AutoResume is enabled on the adapter:
Management Menu
→ Objects→ Adapter→ AutoResume.)
The initialization is stopped, and the CU stores the percentage
of the initialization already completed. If AutoResume is enabled,
and if Fast Init is not enabled, the initialization resumes where it
left off when you restart it, instead of starting over from 0 percent.
– Continue: The initialization continues normally.
– Abort: The initialization is completely aborted. If you restart
initialization, it begins at 0 percent.
(Second Initialization Method) Follow these steps to initialize a logical
drive using the Objects menu.
1. From the Management Menu, select Objects
→ Logical Drive, as
shown in Figure 3.3 .
A list of configured logical drives appears.
Figure 3.3 Logical Drive Submenu
2. Select a logical drive, if there is more than one configured, and press
Enter.
3. Select Initialize from the submenu and press Enter.