MyWeigh 1SCALE - Manual

1scale Owner's Manual
Low Batteries, bad battery connections & Faulty AC Adaptors are the #1 cause of scale malfunction
and inaccuracy! We test all of our scale returns from consumers. Fully 60% of consumer returns are
battery related problems. This sounds silly but it's true! A scale will perform slowly, or read inaccurately
when it has low batteries. Please replace the batteries often (and only use good quality batteries). We
include good quality batteries with all of our scales but batteries can run low in storage. If your scale
simply won't turn on while on Battery power, this is often caused by loose battery connections. Battery
prongs (terminals) are made of metal. They must be making good contact with your batteries in order
for the scale to power on. You can use a paperclip to slightly bend the battery prongs to make them
have a better connection. Also some poorly designed batteries have recessed or partially obstructed
battery terminals. This may cause your prongs to be touching the plastic housing of the battery instead
of the metal battery terminal. A Faulty AC adaptor can cause your scale to act unstable with numbers
"jumping" all around. Please test your scale with a good set of batteries (instead of the AC adaptor) to
determine if perhaps the AC adaptor is faulty.
This page contains operating instructions for the 1Scale 200 and 1Scale 2000 and Advanced
Programming for the 1Scale 200. Please make sure you are looking at the correct manual for your
model scale.
1SCALE 2000 OPERATING INSTRUCTIONS
The 1scale is very easy to operate. However, there are certain caring and operation instructions you
should read before your first use We know taking the time to read these instructions is time consuming,
but this scale is a precision instrument and must be handled with the utmost care.
Technical Specification
Maximum Capacity : 4lbs. 6½oz / 2000 grams
Resolution : 1/8 oz / 1 gram
Power : 4 AAA Batteries
Battery Installation
1. Press and push open the battery cover located at the bottom of the unit.
2. Insert 4 AAA size batteries matching the (+) and (-) polarity covers with the battery. Close the battery
cover until it clicks shut.