Nilfisk-ALTO PS Series - Manual (Page 5)

2. QUICK START - ACTIVE SPEAKER CABINET
3). Turn on your mixer first, then the active speaker cabinets.
-. For Active Speaker Cabinets
QUICK START
PS Active Full-range Speakers
4
Signal Cable
Power Cord
Tripod
Mount
Main Mix
Left
Output
Mixer
Tripod
Mount
Power Cord
Right
Output
Main Mix
Signal Cable
Make all initial connections with all the equipment powered off, and ensure that all the main volume controls are turned
completely down.
1). Connect one side of the signal cable at your audio mixer into output left /right (with Stereo-Jack or XLR) and
the other side of the cable into the line input (COMBO) of your active speaker cabinet (with Stereo-Jack or
XLR).
2). Connect the power cord to mains.
4). Turn up the volume control of the active speaker cabinets.
5). Use PFL function to get the proper input level for the mixer, and adjust the main mix level control to manipulate the
output level.
6). After using, turn off your active speaker cabinets first, then the mixer.