Nostalgia Electrics RMO400 SERIES - Manual (Page 13)

E
N
G
LI
S
H
11
HOW TO OPERATE
CHOOSING A LOCATION
You will use the oven frequently so plan its location for ease of use. Allow at least 2
inches on the sides, top and at the rear of the oven for air circulation. Do not place or
install the oven in any area where heat and steam are generated; for example, next
to or above a conventional gas or electric range or above a conventional wall oven.
Heat and steam may damage the electronics or the mechanical parts of the oven.
AFTER PLUGGING IN
As soon as the microwave is plugged into the outlet, the LED Display will flash three
times. Then the LED Display will flash "
: " which prompts you to enter the time.
SETTING THE CLOCK
•
While the LED Display reads " : ", press the DELAY/CLOCK button once. The
LED Display will then read 0:00 and the 0: on the far left will flash.
• Turn the PROGRAM DIAL clockwise to change the hour to single digit numbers.
Turning it counterclockwise will change the hour to double digit numbers.
• Continue to rotate the PROGRAM DIAL in the desired
direction until you have the correct hour.
• Once you have set the hour, press the DELAY/CLOCK button again to confirm your selection.
• Now the :00 on the right will flash. Follow the same directions
above for setting hours to set the correct minutes.
• Once you have set the correct time, press the DELAY/
CLOCK button again to confirm your selection.
CONTROL PANEL
PROGRAM DIAL
The PROGRAM DIAL is a multi-functioning controller. It can be used to set the time
on the clock, adjust cooking time and to select a pre-defined cooking program.
• Quick Start: Pressing the PROGRAM DIAL once will immediately
start a cooking cycle for one minute at maximum power.
• Adjusting Time: You can adjust the cooking time by either pressing the PROGRAM DIAL
additional times to add 30 second increments, or turning the PROGRAM DIAL clockwise
to increase time by seconds and counter-clockwise to decrease time by seconds.
• Selecting a Cooking Program: Turning the PROGRAM DIAL counter-clockwise prior to
starting a cooking cycle allows you to select a cooking program. The LED Display will light
up to show which program is selected. Program selections are: BEV (Beverage, cook), POP
(Popcorn, cook), FROZ (Frozen Entrée, cook), VEG (Vegetable, cook), SPUD (Potato, cook),
RICE (Rice, cook), BRED (Bread, reheat), PIZZ (Pizza, reheat), DISH (Dinner Plate, reheat),
FISH (Fish, defrost), CHIC (Chicken, defrost), BEEF (Beef, defrost). Once you have selected
your desired program, press the PROGRAM DIAL. The LED Display will then prompt you
to select the weight or number of food items. Turn the PROGRAM DIAL again to select the
weight or number of food items and press the PROGRAM DIAL to begin the cooking cycle.
• Note: PROGRAM DIAL will only work:
a) Within 2 minutes after closing the door
b) Within 2 minutes after pressing the STOP button