Revolabs HD Single & Dual Channel User and - Manual (Page 10)

- 10 -
To Install the Base Station:
1. Plug the power cord into an appropriate outlet
2. Connect the necessary outputs and inputs
Revolabs HD™ Base Station Audio Connections
There are (2) 3.5mm balanced inputs and (2) 3.5mm balanced outputs on the back panel of the unit
providing access to each channel’s audio signal.
The three terminals correspond to:
Tip = Positive +
Ring = Negative –
Sleeve = Shielded Ground
There are one or two output channels representing a separate channel for each microphone. The
microphone output connectors need to be attached to the input connectors of an audio mixer.
The Base Station input connectors (also 0 dBu) may then be attached to mixer channel outputs.
Because the system is full-duplex, the input connections provide the ability to hear program audio
using a 2.5mm earpiece attached to the microphone (supplied with the wearable microphone).
Depending on the application, it is possible to feed a single audio feed back to each earpiece. This
would allow for translation, personal hearing assistance or other services to be incorporated into an
application.
NOTE: The USB port may exhibit static sensitivity. If the Base Station audio shuts down after
handling, please power cycle the Base Station
Note: The HD Single/Dual System is not compatible with any other Revolabs system and
therefore cannot be installed in the same room. The HD and Solo Wireless Microphones and
Charger Bases are not interchangeable. No more than one HD Single/Dual system can be used in
a single room. Please contact [email protected] for design recommendations.
Configuring the Revolabs HD TM Base Station
Each Revolabs HD
TM
Base Station must be configured properly prior to use. Accurate configuration is
dependent on several variables such as:
• Is Line Level or Mic Level signal required?
Refer to setting Dip Switch 3 below.
• How many HD TM
Dual/Single Systems are being used together in close proximity?
If you have more than one Revolabs Wireless Microphone System, refer to setting Dip
Switch 7&8 below. Note: It is recommended that the lowest functioning Transmit Power
be used for each system.
• How large is the room?
Refer to setting Dip Switch 7&8 below. Note: It is recommended that the lowest
functioning Transmit Power be used for each system.