Revolabs Fusion Microphone System — Tandberg C20 - Manual (Page 2)

Connecting the Cables
1. Connect the XLR – 3.5mm 4 conductor audio cable between the XLR ―CONF
OUT‖ port on the Fusion and the ―MICROPHONE 1‖ port on the Tandberg C20.
2. Connect a Male RCA-RCA audio cable between the ―CONF IN‖ port on the
Fusion and the White ―AUDIO OUTPUT‖ port on the C20.
3. Connect a Male RCA audio cable between the ―Room Out‖ port on the Fusion
and the Amplified Speakers.
3
1
2
NOTE: You must use your Fusion remote control to control the room volume
for both the audio and video conference calls. Adjusting the volume in the
video codec will cause echo.
T ANDBERG C ODEC C20 A DMINISTRATOR ’ S G UIDE © J ULY 2009
1
+
-
2