Revolabs Single Channel System - Polycom HDX 9004 - Manual

Revolabs Single Channel System - Polycom HDX 9004 Setup Guide
N OTES AND C AUTIONS :
This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Polycom HDX 9004 video codec.
1. Connecting the Cables
2. Configuring the HDX 9004 Video Codec
Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Single Channel System
2. Revolabs 2.5mm to RCA Audio Cable (included with Single Channel)
3. Polycom HDX 9004 video codec
4. Polycom Audio Adapter Cable (P/N 2457-23492-001) or equivalent*
*P
OLYCOM
HDX 9000
SERIES VIDEO CODECS HAVE PHOENIX CONNECTORS FOR AUDIO INPUT
/
OUTPUT WHILE
R
EVOLABS
S
INGLE
C
HANNEL
S
YSTEM PRODUCTS USE
RCA
CONNECTORS FOR AUDIO INPUT
/
OUTPUT
. T
HE
P
OLYCOM AUDIO ADAPTER
CABLE CONVERTS TWO PHOENIX CONNECTORS INTO FEMALE RCA CONNECTORS . O THERWISE , A TECHNICIAN COULD SIMPLY
CUT OFF THE ENDS OF THE RCA CABLES AND CONNECT PER THE DIAGRAM ON THE FOLLOWING PAGE :