Seiwa MDS-18910R User Manual
Page 14
MDS-1R/8R/9R/10R Installation
11
Note
The recommended mounting surface thickness is 3/8 to 1/2 in. (9 mm to 13 mm). If the
mounting surface is thin, a doubler should be added. If it is thicker, longer bolts must be
purchased. The scanner will be damaged if bolts penetrate more than 9/16 in. (15 mm).
Also, consider the cable route from the scanner to the operator’s location. Avoid routing the
interconnecting cable through areas of possible damage from moving objects, machinery,
exposure to chemicals or high temperature.
Prepare RADARpc For Installation
Unpack your new RADARpc and check the contents against the packing list. Do not remove
the cover from the unit. There are no connections or adjustments inside the unit that are
needed for installation or operation. The cable must remain attached. For ease of handling,
coil the cable and place it on top of the scanner. Then secure it with tape. Invert the scanner
and make sure the four mounting holes are clear to accept bolts.
Working at higher elevations may become necessary while installing the scanner unit.
Observe safety measures and take sufficient precaution to avoid personal injury or damage to
the equipment.